Retardation characteristics and birefringence of a multiple-order crystalline quartz plate

A crystalline quartz plate of thickness 1.070 mm is calibrated between 370 and 794 nm. Throughout this spectral interval, the retardance varied by 32π and the plate introduced quarterwave retardance 16 times at different wavelengths. The birefringence (n_e−n_o) of crystalline quartz was calculated as a single quantity and varied from 0.00971 at 370 nm to 0.00891 at 794 nm. All measurements were carried out at 23°C.     

Gas solubility of carbon dioxide in poly(lactic acid) at high pressures: Thermal treatment effect

The sorption of carbon dioxide in glassy Poly(lactic acid) (PLA) films was studied by quartz crystal microbalance (QCM) at high pressures. Two thermal treatments, melted and quenched, were performed in PLA with two different L:D contents, 80:20 and 98:2, films and compared with a third thermal protocol, annealed, and used in a previous work. The results obtained show that for pressures higher than 2 MPa, the carbon dioxide solubility is larger in PLA 80:20 than in PLA 98:2, indicating that the L:D plays a dominant role on this property. The thermal treatments only affect the gas solubility in PLA 98:2. Sorption isotherms at temperatures 303, 313, and 323 K, below the glass transition temperature of the polymer, and pressures up to 5 MPa were measured and analyzed with three different models, the dual‐mode sorption model, the Flory–Huggins equation, and a modified dual‐mode sorption model where the Henry's law term was substituted by the Flory–Huggins equation. This last model performs especially well for CO₂ in PLA 80:20, due to the convex upward curvature of the solubility isotherms for that system. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 616–625, 2007     

In‐line monitoring of UV photopolymerization with a quartz crystal resonator

An in‐line monitoring device using a quartz crystal resonator for thin film polymerization was proposed, and its performance has been evaluated by implementing in the UV polymerization of 2‐hydroxyethyl methacrylate with a photoinitiator of 1‐chloroanthraquinone. Because the variation of resonant resistance of the resonator is proportional to the square root of viscosity change that is closely related to the polymerization degree, the resistance can be used as a measure of the polymerization degree. The resistance measurements were compared with the outcome of instrumental analyses of polymerization degree using an FTIR spectrometer and a gel permeation chromatograph. The experimental results showed that the resistance measurements were consistent with the experimental outcome of the instrumental analyses, and this indicates the effectiveness of the proposed device. Owing to the simplicity and availability of the resonator system, its wide utilization in the monitoring of a variety of film polymerization processes, including photoresistor application, is expected. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 2428–2439, 2006     

石英晶体微天平技术研究纳米TiO_2表面Cu(Ⅱ)吸附与光化学还原过程

环境中排放的重金属离子Cu!对水生和陆生生物有强的毒害性。饮用水中Cu!的浓度高于1.0mg·L-1时,将会导致人畜得血色沉着病和胃肠粘膜病[1]。Cu!无法进行生物降解,除去废水中Cu!的常见方法有离子交换、置换、化学沉淀等[2],然而这些方法需要消耗大量的化学试剂,成本高。近来,研     

动力学—压电石英晶体传感器测定水中微量汞的研究

基于涂银压电石英晶体对ＣＮ＾－离子的灵敏响应，应用汞对六氰合铁酸钾与邻二氮杂菲反应的动力学催化作用，建立了动力学－ＰＱＣ传感器单面触液测定微量汞的新方法。研究了ＰＱＣ传感器对汞的响应机理，响应曲线，实验条件及共存离子干扰情况。     

Biomimetic piezoelectric quartz sensor for caffeine based on a molecularly imprinted polymer

A piezoelectric quartz sensor coated with molecularly imprinted polymer (MIP) for caffeine was developed. The MIP was prepared by co-polymerizing methacrylic acid (MAA) and ethylene glycol dimethacrylate (EDMA) in the presence of azobis(isobutyronitrile) as initiator, caffeine as template molecule, and chloroform as solvent. The MIP suspension in polyvinyl chloride/tetrahydrofuran (6:2:1 w/w/v) solution was spin coated onto the surface of the electrode of a 10 MHz AT-cut quartz crystal. The sensor exhibited a linear relationship between the frequency shift and caffeine concentration in the range of 1×10^–7 mg mL^–1 up to 1x10^–3 mg mL^–1 [correlation coefficient (r)=0.9935] in a stopped flow measurement mode. It has a sensitivity of about 24 Hz/ln(concentration, mg mL^–1). A steady-state response was achieved in less than 10 min. The performance characteristic of the sensor shows a promising and inexpensive alternative method of detecting caffeine. Surface studies were carried out for the reagent phase of the sensor using SEM, AFM, and XPS analysis in order to elucidate the imprinting of the caffeine molecule. The SEM micrograph, AFM image, and XPS spectra confirmed the removal of caffeine by Soxhlet extraction in the imprinting process and the rebinding of caffeine to the MIP sensing layer during measurement.     

Transport of ionic charge and solvent in poly(3-octylthiophene) films: An electrochemical quartz crystal microbalance study

The results of a study of poly(3-octylthiophene) films with the aid of an electrochemical quartz microbalance are presented. The effect of the nature of the electrolyte anion on the determined weights of mobile species that are transported through the film/electrolyte interface is discussed. The obtained results point to a substantial role played by the solvent transport in the course of the electrode reaction. The results concerning the influence exerted by the electrode material on the observed regularities are presented.     

Aspects of thermal conductivity relative to heat flow

Summary The various techniques and methodologies of thermal conductivity measurement have been conventionally based on the determination of the rate of directional heat flow through a material having a unit temperature differential between its opposing faces. The constancy of this rate depends on the material density, its thermal resistance and the heat flow path itself. The last of these variables contributes most significantly to the true value of steady-state axial and radial heat dissipation depending on the magnitude of transient thermal diffusivity along these directions. The purpose of this paper is to exemplify the above features by defined parameters of heat flow measurement by existing methodologies. No new method is proposed here. Importantly, the relationship between the rate of heat transfer, total heat transferred and thermal conductivity at a given temperature under steady-state conditions for a fixed heat flow path will be illustrated.     

Monitoring formation of poly(neutral red) film by EQCM

An electrochemical quartz crystal microbalance (EQCM) is employed for monitoring the growth of poly(neutral red) films on platinum in the electrolytic solution containing 5.0 mmol dm⁻³ neutral red, 0.3 mol dm⁻³ H₂SO₄, and 0.5 mol dm⁻³ Na₂SO₄. The in situ measurement of the frequency changes of the EQCM reveals that both the adsorption/desorption of neutral red and the formation of poly(neutral red) film can be observed together with anion sorption/desorption during the redox transformation of the polymer, and that the polymerization rate of neutral red increases slowly before the 11th cycle and then increases quickly with increasing number of potential cycles. Published in Russian in Elektrokhimiya, 2007, Vol. 43, No. 3, pp. 284–289. The text was submitted by the authors in English.     

卵磷脂抗石英毒作用的研究

本文采用家兔肺泡巨噬细胞(AM)体外培养法,以细胞内游离钙浓度([Ca~(2+)]_i)、细胞存活率、乳酸脱氢酶(LDH)和酸性磷酸酶(ACP)活性为指标,观察了卵磷脂、脑磷脂及现用防治硅肺药物克矽平(PVPNO)、柠檬酸铝等抗石英毒效果。结果表明:卵磷脂在所试各药物中效果最佳.初步探讨了卵磷脂拮抗石英细胞毒性的机理.卵磷脂有成为防治硅肺药物的可能性.